Skip to content

Software update

As of software release 2.1.0 the system automaticly checks for updates when the host computer is connected to internet. If you have the latest release you will see a green checkmark as shown below. A warning will indicate if a newer release is available.

sw_version

A software update package (.wlup file) includes all files required to update the system. Some software updates also requires an update of the low-level FPGA image. The FPGA image is encrypted with a unique key. To generate a new FPGA image for your board, Water Linked needs to know the Chip ID of your board. The Chip ID can be found in the About tab of the GUI. To get the latest software package for your kit, go to update.waterlinked.com and enter the Chip ID of your kit.

Update process

Step Description
1 Power off the system
2 Set Master-D1 to fixed IP “192.168.2.94” See chapter 3.1
3 Set the IP on your own computer to be on the same sub-net
4 Power up the system while at the same time keeping the GPIO0 pin on the GPIO connector grounded with the upgrade plug included with the kit upgrade_plug
5 Go to web GUI http://192.168.2.94
6 After the system has booted and you see the upgrader GUI, remove the grounding of GP0.
7 Click “Browse file” and select correct <>.wlup file
8 Wait for update process to complete
9 When the update process is complete and successful, the system will automatically reboot to standard mode
10 Verify that the SW version has updated