Skip to content

Network Settings

At power-up, the Master-D1 reads the DIP-switch settings. The network mode depends on the GP0 and GP1 position.

Network mode GP0 GP1 DIP switch position
DHCP client ON ON
Static IP OFF ON
Static custom IP ON OFF

The BS0 and BS1 positions on the dip switch shall both be ON. These boot-select pins are used in factory programming only.

Use the supplied Ethernet cable to connect the Underwater GPS to a network switch or directly into the host computer.


The host computer connected to the topside unit needs to have an IP-address on the same subnet as set on the Master-D1. For example: If the IP address of the UGPS is the host computer needs to be configured to a different 192.168.2.x address e.g.